Once you see your unit's interface or you can access the Menu from the other monitor, start changing the resolution. TIP: If you are having issue with your VGA display, grab a separate display and connect it via HDMI or vice versa. To resolve that, you need to temporarily use a separate display until you can see the recorder's interface again. If upon booting up the system, the Swann logo shows but after that it displays Video Mode Not Supported or Signal Out of Range or just a black screen, this means your recorder's resolution is set higher than what your display monitor can handle or is not compatible. Video Mode Not Supported or Signal Out of Range error Kindly check your Quick Start Guide that came with your kit. Try a different display - if you were using HDMI, either try another HDMI display or use VGA for testing.DVR is connect to HDMI2, then the display's channel should be in HDMI2 as well) Ensure you are in the right channel / input based on where the recorder is connected (e.g. Select the correct input - some TVs have more than 1x VGA or HDMI.Some recorders has switch at the back so make sure to check it.If your display shows No Signal while connected to your recorder, then you need to check couple of things. Video Loss Troubleshooting for NVRs (basic connections).Video Loss Troubleshooting for DVRs (basic connections).If you can access the recorder's Menu interface but can't see the cameras or you are getting Video Loss or No Video indicators, take a look at the articles linked below:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |